JCM GAMMA VERSUS Series, Manual

Page: 100 / 111

GAMMA VERSUS MANUAL
100
COD. 1257066 Gamma VERSUS Manual v1.13
System Check (Check function)
Press the receiver’s CHECK button for at least 1 second to enter check mode. The indicator light will come on and
four beeps will be heard.
Perform a complete door opening and closing manoeuvre. During the system check a beep will be heard every 1,5
seconds.
To exit Check mode, press the CHECK button or wait 5 minutes. On exiting check mode, seven consecutive beeps
will be heard and the indicator light will flash continuously.
If the communication fails:
- In case you work with RB3, halt the door manoeuvre and press the safety edges installed to detect what
has failed.
- In case you work with RS3, halt the door manoeuvre and check in operating mode (outside the Check
function) that the D” green led indicates a coverage failure too.
Perform another system check until the result is correct.
Press the safety
edges
Nº flashes
check led
Signal
coverage
Result of
check
Solution
Three consecutive
beeps are heard
1 Very weak Safety
edge
failure
Change the orientation of the transmitting-receiving aerials or
install an AED-868 or FLAT-868 outdoor aerial to ensure the
desired range.
2 Weak OK The battery consumption will be higher
A single beep is
heard
3 Normal OK
A single beep is
heard
4 Good OK
A single beep is
heard
5 Very good OK
Reset
PRESS RPROG PUSHBUTTON LED TURNS ON BRIDGE MR SEVERAL BEEPS & END RESET
AND HOLD PRESSED
PRESS RPROG PUSHBUTTON LED TURNS OFF & END PROG
VERSUS
Control
panel
Leds INX
ON No beeps INX Input connection error Connect correctly or program the
safety transmitter into the receiver
VERSUS
Control
panel
Leds INX
ON
--- Safety input activated
VERSUS
Control
panel
Leds INX
flashing --- Closing or opening with safety
activated