JCM GAMMA VERSUS Series, Manual

Page: 52 / 111

GAMMA VERSUS MANUAL
52
COD. 1257066 Gamma VERSUS Manual v1.13
7.17 Closing security contact inhibition function
Model All
Associated
parameters
ID Description Type
P08 SEC.CL inhibition ON/OFF
P18 SEC.CL programmed ON/OFF
P3B SEC.CL inhib. point NUMERIC
P42 Inhib. zone start point NUMERIC
Description
The closing security contact function allows inhibit the closing security contact for a
specific zone of the closing maneuver. This function is used in 2-leaf up and over
doors that are installed in such way that the door passes in front of the closing
security contact when it executes the closing maneuver.
Configuration
To enable the closing security contact inhibition function it is needed to set the P08
configuration parameter to ON by means of a VERSUS-PROG programming tool.
After enabling this function the control panel sequence must be programmed in order
to detect the security contact activation (activated by the door) and this activation
defines the security contact position.
If the security contact is activated during the programming of the closing maneuver
P18 configuration status parameter is set to ON.
The inhibition zone is defined by the sum of the following two parameters:
- The programmed security contact position is defined by the configuration
status parameter P3B . This parameter is stored during programming
sequence if security contact is detected. This is a position parameter and its
units are seconds or pulses depending on the working mode (time or Hall).
- The inhibition margin is defined by the configurable parameter P42. This
parameter is the same that is used in order to define the security edge
inhibition zone. It is a position parameter; therefore its units are seconds or
pulses depending on the working mode (time or Hall). This margin is added to
the previous security contact position to get as result the whole inhibition
zone.