JCM GAMMA VERSUS Series, Manual

Page: 51 / 111

GAMMA VERSUS MANUAL
51
COD. 1257066 Gamma VERSUS Manual v1.13
7.16 Closing security wired edge or Radioband inhibition function
Model
All
Associated
parameters
ID Description Type
P06 Inhib. 4cm S.EDGE.CL ON/OFF
P42 Inhib. zone start point NUMERIC
Description The security edge inhibition function allows inhibit the closing security edge activation
during the last closing maneuver centimeters. This function is common for wired 8K2 or
optical security edges and for Radioband system.
Configuration
To enable the closing edge inhibition function it is needed to set the P06 configuration
parameter to ON by means of a VERSUS-PROG programming tool.
The inhibition zone is the last centimeters of the closing maneuver and it can be
configured by means of the
P43 configuration parameter. This parameter is a position
parameter and the units that are used depend on the time or Hall mode configuration. If
the control panel is working on the time mode seconds are used as units and the
inhibition zone can take values from 0 to 180 seconds. On the other hand, if control
panel is working on the Hall mode pulses are used as units and the inhibition zone can
take values from 0 to 18000 pulses. This inhibition zone value is common for normal
8K2 wired edge, optical wired edge or Radioband controlled edge.
Operating
After closing edge inhibition function is configured and enabled, in normal operation
when there is security activation due to an 8K2 closing edge, optical closing edge or
closing Radioband it is not taking into account and the door will continue the closing
maneuver.
Notes VERSUS control panels are ready to directly control WITT ( http://www.witt-
sensoric.com/ ) and FRABA ( http://www.fraba.com/ ) wired optical edges.
P42 Inhibi. zone
start point