JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 10 -
1. First steps
1.1 Scope of delivery and installation
Lighting control console
Connecting cable
User manual
USB-cable
Optional accessory:
Desklamps
Flightcase
Dustcover
Trackball
Please check whether delivery is complete
Ensure that the voltage complies with the power unit settings and plug in the power unit. The factory
setting of the console is 230 V. After plugging in the controller, the LED of the ON/OFF key is lit. If this is
not the case, throw master switch of the power unit and activate the control console by pressing the
ON/OFF key.
1.2 Changing the input voltage
The input voltage of the Licon 1X is adjusted with a slider situated beneath the mains plug. You can
choose between 230 V and 115 V. Set the required voltage with a suitable tool (e.g. screwdriver) before
you plug in the console. Move the red slider located between the mains socket and the mains plug to the
right (115 V) until it locks, or move it to the left (230 V) until it locks. If no red slider is present on the
power supply unit of the lighting control console, please contact our service team before you carry out the
voltage setting.
1.3 DMX outputs
The Licon 1X has four DMX output sockets. These are 5-pin sockets with the following occupation:
Pin 1
shield
Pin 2
data –
Pin 3
data +
Pin 4
not occupied
Pin 5
not occupied
Since DMX boosters are generally required for very long DMX lines (where many devices are connected),
the Licon 1X is equipped ex works with a DMX booster. This means that two output sockets are available
per DMX line with 512 channels. The output sockets are designated A1 and A2 or B1 and B2,
respectively.
