JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 75 -
14. Editing a chase in the Combi section
The parameters of a chase can only be edited in the Edit Chase menu (press Edit key in the Combi
section) with the exception of the manual modification of the chase speed, which is performed in the
Chase Control section.
The Edit Chase menu display has the following structure:
If you have entered the Edit Combi Chase menu, select the
desired chase step with the middle encoder wheel (STEP).
14.1 The LINK F function
Use the softkey LINK F to select whether the fade time is processed in absolute numbers, i.e. in seconds,
or as percentage values depending on the NextTime.
LINK F inverted:
in percent
LINK F not inverted:
in absolute numbers
14.2 The SINGLE function
Use the softkey SINGLE to enter whether the chase runs permanently as loop or only once.
SINGLE inverted:
chase stops after the last chase step
SINGLE not inverted: chase runs permanently as loop
14.3 The FLASH function
The FLASH function can only be used in combination with a release link. If a FLASH function is assigned
to a chase, this chase is only active as long as the chase key is pressed.
Enter the release link as described in Chapters 6.1.7 and 6.1.8.
Use the softkey FLASH to activate the FLASH function.
FLASH inverted:
function is active
FLASH not inverted:
function is deactivated
14.4 The NAME function
Use the NAME function to name the chase. If the NAME function is activated, name the chase with the
keys of the CUE/CHASE/SEQUENCE section.
NAME inverted:
function is active
NAME not inverted:
function is deactivated
