JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 20 -
Activating an assigned key with the footswitch:
If you activate a key with assigned remote function during a show, the current PAGE/BANK settings are
applied.
As an example: you have assigned the key Chase 1 to the command GO – .
If e.g. Page 2, Bank D is active during a show and you apply the footswitch (GO-), then the chase is
automatically activated that was stored on Page 2, Bank D, key M1.
If e.g. the PAGE/Bank setting Page 1, Bank C is active, then the chase will be activated that was
previously stored with this setting.
This means that a key is assigned independently of the currently active pages or banks.
Press the ESC key to leave this menu.
2.9.2 Assigning softkeys
It is also possible to use the footswitch for activation of the softkeys on the display.
For this purpose, select either GO – or GO + with the middle encoder wheel and then press the softkey
that you wish to activate with the footswitch. The softkeys no. 1, no. 2, no. 3, no. 13, no. 14 and the
Escape key cannot be activated by pressing the key directly, but by pressing the softkey S-KEY several
times.
The assignment is shown on the display as follows:
You can repeat the procedure with the second GO function or
assign another key.
Press the ESC key to leave the menu.
2.9.3 Assigning keys dependent on PAGE/BANK
If you wish to assign to the footswitch a particular key with previously programmed
PAGE/BANK settings, proceed as follows:
Use the middle encoder wheel to select either GO+ or GO- .
Press the softkey DIRECT.
Then consecutively press the desired key of Page, Bank and
Cue/Chase/Sequence.
In the display, the corresponding assignment is confirmed.
Press the softkey DIRECT again to leave the menu.
