Japan Tiger Fast Ethernet 7100e+, User Manual

Page: 158 / 160

Fast Ethernet
7100e +
158
Setting from BOOTP
BOOTP is a protocol for assigning IP addresses which have been
registered on a BOOTP server to each host on the TCP/IP network.
The printer will acquire an IP adddress when it is turned on.
• This function is not available unless there is a BOOTP
server on the network.
• [DHCP/BOOTP protocol] on the Fast EtherNet needs
to be set to [ENABLE]. If it is set to [DISABLE], change
the setting to [ENABLE], referring to Printer
Preparation.
The following description uses the HP-UX 9.x BOOTP server as
an example. If you use any other OS, make the same settings
according to the manual for your workstation.
1 Register the IP address of the Ehternet board and host name
in the /etc/hosts file.
Example: If the IP Address is “192.168.20.127” and host
name is “OP8C”.
192.168.20.127 OP8C
2 Add the following settings to the /etc/bootptab file.
Example: If the IP Address is “00:80:92:00:11:BC”
OP8C:\ The host name registered
in /etc/hosts
ht=ether:\ Set the hardware type
to “ether”
ha=0080920011bc:\ Ethernet address
ip=192.168.20.127:\ IP address
sm=255.255.255.0:\ Subnet mask
gw=192.168.20.254:\ Gateway
3 Add the following settings to the /etc/inetd.conf file.
bootps dgram udp wait root /etc/bootpd bootpd
4 Reboot the inetd.
# kill -1 1
5 Switch the printer on.
7100e+.p65 25/08/99, 20:56 PM 158