Japan Tiger Fast Ethernet 7100e+, User Manual

Page: 141 / 160

User Manual 141
English
Setup Value
Default value
None
Default value
255 sec.
1 : Permitted
2 : Not permitted
ENABLE : To use the function
DISABLE: Not to use
the function
ETHER-II:
ETHERNET-II
802.2 : IEEE802.2
802.3 : IEEE802.3
SNAP : SNAP
PRINTER :
Remote Printer Mode
PSERVER :
Print Server Mode
Function
Set MIB-II SysLocation. This can be up to 79
characters/numbers.
Set IP Packet Existing Value (TTL Value).
Normally, use the default value. The value may
vary from 0 to 255 sec.
Set whether Authentic Trap Error is permitted.
Set whether NetWare protocol (IPX/SPX
protocol) is used.
Designate the packet frame type used for
NetWare. Make it identical with the frame type
of the existing network.
Choose Ethernet Board operating mode for
NetWare from Print Serer Mode or Remote
Printer Mode. This setting should coincide with
that on NetWare Server.
Items
SysLocation
DefaultTTL
EnableAuthenTrap
NetWare
NetWare protocal
Packet type
NetWare mode
Default value
All None
Default value
"ML"+"last 6 digits of
MAC Address"
Default value
Null (No password)
Default value
4 sec.
Enter File Server Name which administer
Printer in Print Server Mode. A maximum of 8
file servers may be designated at max. The
value should be in 31 or shorter alphabets or
numbers.
It is the "Print Server Name" which has been
set at File Server in Print Server Mode. Make
sure this name is identical with the "Print
Server Name" set at File Server.
In Remote Printer Mode, it is not used for
NetWare. In both modes, this name will be
displayed at the utility as the machine name.
The value should be in 31 or shorter alphabets
or numbers.
This is a password to log in File Server in Print
Server mode. Make sure this password is
identical to that set at File Server. The value
should be set in 31 or shorter alphabets or
numbers.
Set the interval to poll the job status. The
smaller the value is, the more load on the
network. The larger the value is, the worse the
printing response. Normally, please use the
default value. The value may vary from 2 to
255 seconds.
Print Server
FSERVER name1-8
Machine name
Password
Job polling interval
Enter the Authentic Community Name,
which is a maximum of 15
characters/numbers. The set value will be
displayed as "********".
Enter the Trap Community Name, which can
be up to 15 characters/numbers.
Enter the Trap Notice Address. IP Address
,0.0.0.0, is invalid.
Set MIB-II SysContact.This can be up to 79
characters/numbers.
Set MIB-II SysName.This can be up to 79
characters/numbers.
Default value
public
Default value
public
Default value
0.0.0.0.
Default value
None
Default value
None
SNMP
Authentic
community
Trap community
Trap address
SysContact
SysName
7100e+.p65 25/08/99, 20:55 PM 141