Janome Horizon Memory Craft 15000, Instruction Manual

Page: 29 / 184

Optic Magnifier
Use the magnifier to get a larger view of the needle area.
Attaching the magnifier
Hold the knob with your fingers and insert the pin into the
hole in the bottom of the face plate.
Push the magnifier up until it snaps to fit.
Adjust the angle to get the best view.
q
Pin
w
Hole
Removing the magnifier
If the magnifier is not in use, turn it to the left out of sight
or pull it down to remove.
CAUTION:
Do not use or leave the magnifier in the direct sunlight,
otherwise it may cause a fire or burn.
Do not look at the sun through the magnifier as it can
damage your eyes.
Do not hit or exert excessive force on the optic
magnifier as this may cause damage when it is
attached.
Retractable Sewing Light
In addition to the twin LED lights, the machine is
equipped with a retractable light.
Place your finger in the groove and slide the arm towards
you. The light will turn on automatically.
Adjust the angle of the light to illuminate the working
area.
q
Arm
w
Groove
Push back the arm to turn the light off and store it.
CAUTION:
Do not hit or exert excessive force on the arm of the
retractable sewing light as this may cause damage
when it is extended.
q
w
q
w
Replacing the magnifier
To remove the lens, push or pull the lever
q
to the
opposite side to draw the pin out of the lens.
Remove the lens from the metal.
To attach the lens, insert it into the metal part
e
as
illustrated.
Push or pull the lever
q
to the opposite side to fix the
lens.
Higher numbers
r
indicates stronger magnification.
q
Lever
w
Lens
e
Metal part
r
Number
q
w
r
r
r
e
24