Janome Horizon Memory Craft 15000, Instruction Manual

Page: 116 / 184

111
Stabilizers
To create the best quality embroidery, it is important to
use stabilizers.
How to use:
Attach the stabilizer to the wrong side of the fabric.
You may need to use more than one layer.
For firm fabrics, you may place a thin sheet of paper
under the fabric.
The non-adhesive type should be used when
embroidering fabric which cannot be ironed or for
sections which are difficult to iron.
Cut the stabilizer larger than the embroidery hoop and
set it on the hoop so that the entire piece is fastened to
the hoop to prevent any looseness in the fabric.
Attaching the stabilizer
Place the wrong side of fabric and the glossy side of
the stabilizer together. Fold up a corner of the stabilizer
and fuse it with an iron.
NOTE:
Fold up a corner of the stabilizer, to make it easier
to peel off the excess stabilizer after stitching.
Ironing temperatures vary depending on the kind of
adhesive stabilizer you are using.
Type
Tear-away
Iron-on
Cut-away
Water soluble
Heat-away
Usage
Stable woven fabrics
Knits and all kinds of unstable fabrics
Knits and all kinds of unstable fabrics
Cutwork or lace embroidery
Right side of looped fabrics such as towels to avoid loops
coming through the embroidery
Cutwork or lace embroidery
Property
Made from a fiber that will tear easily.
Adhesive type fusible with an iron.
Non-woven fabric that does not tear.
A thin film that will dissolve in water.
A thin film that will melt away with heat.
Types of the stabilizers
NOTE:
Sticky type stabilizers can be used only for securing a small piece of fabric or work that cannot be secured in the
hoop, or for securing velvet and other napped fabric that would be permanently marked by the hoop.
Clean the bobbin holder after stitching as glue can get stuck on it.