1
Fobbles F2 400w Fog Bubble User Manual
Diagram:
Please follow these operation, safety and maintenance instructions to ensure a long and safe life for your machine.
UNPACKING & INSPECTION
Open the box to make verify product integrity. In the event that the unit’s housing or cable is damaged, do not plug it in and do
not attempt to use it until after contacting your dealer for assistance.
SETUP
•
Remove all packing materials from box and fog machine.
•
Firmly attach trigger control cable to the proper input on the rear of the machine.
•
Place fog bubble machine on a level flat surface, remove fog liquid reservoir cap toward rear of the machine. Fill fog fluid
reservoir with Froggy Fog Brand Fog Fluid. Lower quality fluid can damage the unit. Recap tank.
•
Fill bubble reservoir with a high-quality bubble fluid, such as Froggys Fog Max Bubbles. Lesser quality bubble fluids cannot
withstand the increased pressure of hot fog.
OPERATION
•
Plug power cord into a grounded electrical outlet and switch the main power on via the illuminated red switch.
•
Allow a few minutes for the machine to warm up and for the ready light on the line remote to become illuminated. No
functions of the machine will operate until the unit has come up to temperature.
•
Turning the remote switch on activates the intended function until the unit may need to reheat (depending on settings.)
o
Fog Function – Bubble Wand OFF (O), Fan OFF (O), Fog Fluid Pump ON (-)
o
Haze Function – Bubble Wand OFF (O), Fan ON (-), Fog Fluid Pump ON (-)
o
Bubble Function – Bubble Wand ON (I), Fan ON (-), Fog Fluid Pump OFF (O)
o
Fog Bubble Function – Bubble Wand ON (I), Fan ON (-), Fog Fluid Pump ON (-)
Important:
Monitor fog reservoir fluid level as you operate, running a fog machine empty can permanently damage the unit. If
output is low, pump is noisy or there is no output at all, unplug immediately. Check fluid level, external fuse, remote connection,
and power connection. If all of the above seem O.K., plug the unit in again. If fog does not come out after holding the remote
button down for 30 seconds, check the fluid hose to make sure there is fluid going through it. If you are unable to determine the
cause of the problem, do not simply continue pushing the remote button, as this may damage the unit. Do not allow the fog
liquid to become contaminated, always replace the caps on the fog liquid container and liquid tank right after filling.
