Thread Cutter Switch
After sewing, depress the thread cutter switch
q
on the
right side of the foot control to trim the both needle and
bobbin threads.
Do not depress the thread cutter switch until the start/stop
button turns green
w
.
q
Thread cutter switch
NOTE:
• Threads are trimmed when the thread cutter switch
is depressed for more than 0.5 seconds.
• The thread cutter switch does not work without the
foot control being depressed first.
Placing the thread cutter switch to the left
The thread cutter switch position can be adjusted for
your convenience.
If you wish to attach the thread cutter switch to the left
side of the foot control, follow the procedure below.
NOTE:
Phillips head screwdriver is not included with this
machine.
z
Remove the setscrews A
e
, B
r
and washers
t
with a Phillips head screwdriver.
e
Setscrew A
r
Setscrew B
t
Washer
t
r
t
e
e
q
r
e
e
z
x
c
x
Turn the base plate 180 degrees.
c
Attach the foot control and thread cutter switch
with the setscrews and the washers
t
. Tighten the
setscrews A
e
and B
r
. Be sure that the cable is not
caught between the foot control and the base plate.
w
5
Summary of Contents for Horizon Memory Craft 15000
