47
MAINTENANCE
02- SERVICING
a) DISASSEMBLING
1- Remove the lock screw.
2- Turn the guard cone until the indicated position.
3- Pull the guard cone.
4- Remove the sliding ring.
b) ASSEMBLING
5-Clean and lubricate the male
and female tubes.
6-Install the sliding ring into the
fitting with the grooves pointing
toward the tube.
7-Install the protection guards.
8-Turn the guard cone until the
indicated position.
9-Install the lock screw.
01- CONNECTING
- Check the PTO shaft length.
- Adjust the length by cutting the tubes and
protection guards proportionately.
Note: File and remove all burrs.
- Connect the PTO shaft and install the
safety chain.
Note: Leave some slack on the
chain considering angular
movements.
- Disengage the PTO when making sharp
turns.
fig 1
Lubricate the male and female tubes
and further points as the figure 1.
ATTENTION: ALWAYS STOP THE SPRAYER AND TURN OFF THE TRACTOR
ENGINE BEFORE SERVICING THE PTO SHAFT. ALL KIND OF MAINTENANCE ON
THE PTO SHAFT MUST BE DONE WITH THE USE OF APPROPRIATE PROTECTIVE
CLOTHING, SUCH AS: GLOVES, BOOTS, GOGGLES, ETC.
CONVENTIONAL PTO SHAFT
ATTENTION
ONLY OPERATE WITH PTO SHAFT
EQUIPPED WITH PROTECTION GUARDS.
Summary of Contents for CONDOR B-12
Page 2: ......