jablotron 100+ Manual Download

Page: 5 / 26

2. OPERATING THE JABLOTRON 100

SYSTEM

The security system can be controlled in a number of different ways. To unset the alarm,
authorization in the form of user identiﬁ cation is always required. The system detects the identity of
the users and allows them to operate those parts of the system which they have been assigned to
control. You can choose from different ways of setting with or without authorization. When Standard
authorization type is used, you don’t have to authorize yourself because it is possible to set the
system just by pressing the right segment button on a keypad. The user name, date, and time are
recorded and stored in the system memory every time the system is accessed. This information is
available indeﬁ nitely. Any user can also cancel a triggered alarm (stop sirens from sounding) just by
authorization in any part of the system (depending on their access rights). However, that does not
automatically unset the system (unless the system’s default setting is changed).

Note

: Depending on the conﬁ guration of the installation and system settings, some of the options

described below may not be available. Consult the conﬁ guration of the installation with your service
technician.

Users and their access rights

CODE
AUTHORIZATION

TYPE DESCRIPTION

ARC code

This code has the highest level of authorization to configure the system’s behavior and
is exclusively allowed to perform the system unblock after a triggered alarm.
It can enter Service mode, access all tabs with options including ARC communication
to which it can deny access to a Service technician (Service code). As long as the
“Administrator-restricted Service/ARC right” parameter remains unchecked, the ARC
code can control all sections and PG outputs used in the system. This code enables
to add more Administrators and other users with a lower level of authorization assign
them with codes, RFID tags and cards. It also has a permission to erase alarm and
tamper alarm memory.

The number of ARC codes is limited only by remaining capacity of the control
panel and there is no code set by the factory defaults.

Service code

(Service)

This code can enter Service mode and configure the system’s behavior. It has access
to all tabs with options including ARC communication unless the access is limited
by the ARC technician. As long as the “Administrator-restricted Service/ARC right”
parameter remains unchecked, the Service code can control all sections and PG
outputs used in the system. It can create users with ARC permission, other Service
technicians, Administrators and other users with a lower level of authorization and
assign them with access codes, RFID tags and cards. It also has a permission to
erase alarm and tamper alarm memory. The number of Service codes is limited only by
remaining capacity of the control panel.

By the factory defaults, the code is 1010. The Service user is always on
position 0 in the control panel and it cannot be erased.

Administrator

code

(Main)

This code has always full access to all sections and is authorized to control all PG
outputs. The Administrator can create other Administrator and other codes with
a lower level of authorization and assign them with access to sections and PG outputs,
access codes, RFID chips and cards. This code has permission to erase the alarm
memory. There can be only one main Administrator code which can’t be erased.
When “Administrator-restricted Service/ARC right” is enabled, the administrator code
must be authorized to confirm access for ARC and Service technicians.

By the factory defaults, the code is 1234. The main Administrator user
is always on position 1 and it cannot be erased.

Administrator

code

(Other)

This code has access to sections selected by the main Administrator to which the other
Administrator can add new users with the same or lower level of authorization to control
sections and PG outputs, assign them with access codes, RFID tags and cards. This code
has permission to erase the alarm memory in assigned sections. When “Administrator-
restricted Service/ARC right” is enabled, the administrator code must be authorized to
confirm access for ARC and Service technicians. The number of Administrator codes (other)
is limited only by remaining capacity of the control panel.

There is no code set by the factory defaults.