jablotron 100+, Manual

Page: 19 / 26

EN
39
2.2.1. OPERATING THE SYSTEM USING THE MyJABLOTRON
SMARTPHONE APP
Once a user account is created, the user can remotely monitor and control the system via
the MyJABLOTRON app for Android and iOS smartphones.
2.2.2. OPERATING THE SYSTEM VIA THE MyJABLOTRON WEB INTERFACE
The JABLOTRON 100
+
system can be easily and conveniently operated using your computer via the
internet and the MyJABLOTRON web interface, which is accessible from www.myjablotron.com .
2.2.3. OPERATING THE SYSTEM USING THE VOICE MENU
The system can be controlled from a phone through a voice menu, which guides the user through
a series of options in the preconfi gured language. To access the voice menu, you just dial the alarm
system’s phone number.
Access to the voice menu can be enabled either to all telephone numbers without restrictions
or alternatively only to authorized phone numbers stored in the control panel. Depending on
the confi guration, authorization by entering a valid code on a phone keypad may be required.
When the user enters the menu, the system will give an update of the current status of all sections
assigned to the user. The caller then can control these sections, either individually or collectively,
using phone keypad and available menu options.
The system default is set up to answer incoming calls after three rings (approximately 15 seconds).
2.2.4. OPERATING THE SYSTEM USING SMS COMMANDS
SMS commands can control individual sections and programmable outputs just like keypad
segment buttons. The form of text message to operate the system is: CODE_COMMAND.
The actual commands are predefi ned (SET/UNSET) with an additional numeric parameter which
identifi es a specifi c section. One SMS can control multiple sections at the same time. In this case,
added numbers in the command defi ne sections.
Example of an SMS command used to set sections 2 and 4.
CODE_SET_2_4
The commands to control the programmable outputs can be programmed by a system installer.
For example, you may choose BLINDS DOWN as your command to close the blinds on your
windows. It is also possible to confi gure the system not to require a code before a command.
In such case the command is simply automatically identifi ed when the system recognizes the user’s
phone number from which the SMS was sent. Confi guration is done by a service technician.
2.2.5. OPERATING THE SYSTEM REMOTELY USING A COMPUTER
(J-LINK)
The JABLOTRON 100
+
system can be operated remotely using a computer with an installed J-Link
software. It can be downloaded from the www.myjablotron.com website.
2.2.6. CONTROLLING THE PROGRAMMABLE OUTPUTS (PG)
2.2.6.1. KEYPAD SEGMENT
A PG output switches on by pressing the right button of the segment and switches off by pressing
the left button. If the output is confi gured as a pulse output, it is switched off according
to the pre-set time. PG control may or may not be stored in the control panel’s event memory.
Confi guration is done by a service technician.
Authorization is/is not demanded based on the system confi guration.