S a f e t y n o t e s
- 7 -
The actuator may be used only for the purpose it was designed.
Open the electric rotary actuator only so far as it is described in this documentation.
Before mounting the actuator is the ease of movement of the actuator to consider.
All cables that are to be connected to the supply, before the electrical installation.
Upon completion of maintenance or repair, check the correct function and possibly adhering to
the target angular position of the actuator and the function of the adjusted to the angular
positions switch.
To clean the housing, do not use abrasive, corrosive or flammable cleaners or high-pressure
cleaning equipment.
Settings and Commissioning
Make sure that the starting or the test settings on the actuator, no potential hazards to personnel
or the environment.
If necessary, set up warning signs, so that unintentional operation is prevented.
During commissioning of the electric part turn actuator manually or electrically, the position of an
attached valve is changed. This allows the flow of gases, vapours, liquids, etc. are enabled or
interrupted.
Check that the valve is actually closed 100 percent when the controller signals the
corresponding position!
Avoid being trapped by suitable measures that by moving parts limbs.
