- 21 -
Electrical Installation
Attach the connector to the actuator and secure it with the provided screws. Tighten the cable
glands so tight that the effective strain relief and grommet set of protection (IP) corresponds. If too
large cable diameter, sub-distribution is provided. Route the two cables to their origin positions
(possibly in conduits or cable shafts). A drip loop shall be provided at the cable laying. Make sure
that the cables are not pinched or sheared off and they are not under pressure or strain. Do not route
the control cables in parallel to other cables that lead to large electricity consumers. Strong
electromagnetic fields could induce currents in the control lines, which may lead to malfunction,
possibly shielded cables must be used.
Mechanical connection of power supply and control line
•
loosen the fixing screw of the plug and pull it from the actuator terminal
•
open the plug by pulling the clamp from the housing
•
lead the cable through to the cable gland on the connector housing
•
connect the cable according to the wiring diagram
•
Secure the cable glands on the plugs
Wiring
See wiring in appendix
