- 25 -
Tool
:
One special plastic wrench. The wrench was supplied with the actuator and mounted inside
the housing .To move the cams, introduce the special plastic wrench in the hole of the cam and turn it
round (see both options on the enclosed pictures).
Tool
A turn flat to flat adjust the travelangel 2º
A comlete turn adjust the travel angel about 12°
P o s i t i o n A d j u s t m e n t
To ensure that the position confirmation works, adjust the confirmation cams (3 & 4)
3° (+/-1º) before the motor stop.
To avoid problems, you should adjust the cams 3
and 4 always about 3 degrees before the engine shut-down.
The standard
actuators are always adjusted at 0º (close) and 90º (open).
To adjust the close position at less than 0º
.
Turn the wrench to clockwise direction - cams 1 and 3.
The cam 3 should press the lever of the micro switch
earlier
than the cam 1.
approximately 3°
To adjust the close position at more than 0º.
Turn the wrench to counterclockwise direction - cams 1 and 3.
The cam 3 should press the lever of the micro switch
earlier
than the cam 1.
approximately 3°
To adjust the close position to more than 90º.
Turn the wrench to clockwise direction - cams 2 and 4.
The cam 4 should press the lever of the micro switch
earlier
approximately 3°
To adjust the close position to less than 90º.
Turn the wrench to clockwise direction - cams 2 and 4.
The cam 4 must press the lever of the micro switch
earlier
than the cam 2.
approximately 3°
4
3
2
1
Setting instruction of limit switches J3C Series
Cam 4: Micro switch potentialfree feedback “OPEN”
Cam 3: Micro switch potentialfree feedback “CLOSE”
Cam 2: Micro switch for engine shutdown “OPEN”
Cam 1: Micro switch for engine shutdown “CLOSE”
