55
6. GAS INSTALLATION AND ADJUSTMENT
6.1. CHECKING GAS TYPE
Use the type of gas suitable for the fireplace you are installing. If you use a type of gas not suitable for the
fireplace refer to a merchant who can recommend a fireplace suited to the type of gas you are using or
provide you with a conversion kit. Bring gas pipes to where the fireplace will be installed.
6.2. INSTALLATION EQUIPMENT REQUIRED FOR GAS LINES
Make sure you have on hand the following items before installing the fireplace:
• An external regulator. The installer must supply an external regulator for propane/LPG connection.
The purpose of the regulator is to reduce incoming gas pressure (Table 6.4). If intake pressure is
not adjusted properly, the
SmartCase
®
’ automatic valve could be damaged (see section 6.4).
• A pipeline network (check local codes).
• CSA approved gas lines sealant.
• A manual valve has to be placed inside the lower compartment of the appliance (before
SmartCase
®
)
(figure 6.2).
• A pressure gauge connection.
• A sediment trap (
recommended
) (figure 6.2).
• An approved flexible gas line equipped with a connector (figure 6.2).
CAUTION
Never connect the gas line directly to the fireplace operating on propane (LPG) or natural gas (NG).
This system requires an external regulator (not supplied). Install the external regulator directly on the
cylinder and adjust the pressure according to the table featured in section 6.4.
WARNING
Connection of gas lines to the appliance must be performed by a certified installer. Observe all local
installation codes.
Figure 6.2
Summary of Contents for loo RGR-25
Page 18: ...18 2 3 FIREPLACE DIMENSIONS 2 3 1 LOO RGR 25 INSERT 2 3 2 MISTRAL RGP 25 PENINSULA...
Page 19: ...19 2 3 3 AUSTER RGCG 25 LEFT CORNER 2 3 4 MOUSSON RGCD 25 RIGHT CORNER...
Page 20: ...20 2 3 5 SIROCCO RGB 25 PANORAMIC 2 3 6 PAMPERO RGC 25 CENTRAL...
Page 21: ...21 2 3 7 SUROIT RGV 25 SEE THRU...
