39
Cut and frame the interior wall where the exhaust vent will go. If the wall the vent goes through is made of
a non-combustible material, an Ø 9½ in. (Ø 24.2 cm) hole is sufficient for a flexible duct; the fireguard will
not be required.
The horizontal length of the vent must be level or have a ¼ in. per foot upward slope.
CAUTION
: Never allow the vent to go downwards. This could lead to improper exhaust venting and cause
a fire.
A firewall is required at each floor level and wherever the
vent goes through a wall.
Slide the vent toward the wall and carefully insert the pipe
into the vent cap. It is important that the vent pipe overlaps
the vent cap on a minimum of 1 ½ in. (3.8 cm). Fasten both
parts together using three self-drilling screws.
Figure 3.2.3.5b
Summary of Contents for loo RGR-25
Page 18: ...18 2 3 FIREPLACE DIMENSIONS 2 3 1 LOO RGR 25 INSERT 2 3 2 MISTRAL RGP 25 PENINSULA...
Page 19: ...19 2 3 3 AUSTER RGCG 25 LEFT CORNER 2 3 4 MOUSSON RGCD 25 RIGHT CORNER...
Page 20: ...20 2 3 5 SIROCCO RGB 25 PANORAMIC 2 3 6 PAMPERO RGC 25 CENTRAL...
Page 21: ...21 2 3 7 SUROIT RGV 25 SEE THRU...