17
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing
properly damage, personal injury or loss of life.
1.
This appliance is equipped with an ignition
device which automatically lights the pilot.
Do not try to light the pilot by hand.
2.
BEFORE OPERATING smell all around the
appliance gas area. Be sure to smell next
to the floor because some gas is heavier
than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
Do not light any appliance.
Do not touch any electric switch; do not use
any phone in your building.
Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
If you cannot reach your gas supplier, call
the fire department.
3.
Use only your hand to turn the gas
control knob. Never use tools. If the knob
will not push in or turn by hand, do not try
to repair it, call a qualified service
technician. Force or attempted repair
may result in a fire or explosion.
4.
Do not use this appliance if any part has
been under water. Immediately call a
qualified service technician to inspect the
appliance and to replace any part of the
control system and any gas control which
has been under water.
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information above
on this label.
2.
Press the power button to the “OFF”
position or set the thermostat to the lowest
setting on the transmitter.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition
device which automatically lights the pilot.
Do not try to light the pilot by hand.
5. Turn off all electric power to the appliance.
6. Close the main gas valve. (Perpendicular
to pipe, 1/4 of turn)
7. Wait five (5) minutes to clear out any gas.
If you then smell gas, STOP!
Follow “B” in the safety information
above on this label. If you do not smell
gas, go to next step.
8. Open the main gas valve. (Parallel to
pipe, 1/4 of turn)
9. Turn on all electric power to the
appliance.
10. Close control access panel
11.
Press the power button to the “ON”
position or set the thermostat to desired
setting on the transmitter
12. If the appliance will not operate, follow
the instructions “To Turn off Gas to
Appliance” and call your service
technician or gas supplier.
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if
service is to be performed.
3. Open control access panel.
4.
Put the battery holder switch to the “OFF”
position.
5. Close the main gas valve. (Perpendicular
to pipe, 1/4 of turn)
6. Close control access panel.
Summary of Contents for loo RGR-25
Page 18: ...18 2 3 FIREPLACE DIMENSIONS 2 3 1 LOO RGR 25 INSERT 2 3 2 MISTRAL RGP 25 PENINSULA...
Page 19: ...19 2 3 3 AUSTER RGCG 25 LEFT CORNER 2 3 4 MOUSSON RGCD 25 RIGHT CORNER...
Page 20: ...20 2 3 5 SIROCCO RGB 25 PANORAMIC 2 3 6 PAMPERO RGC 25 CENTRAL...
Page 21: ...21 2 3 7 SUROIT RGV 25 SEE THRU...
