1
2
550A
113Q
134
134
Item
Description
1.
Taper pin
2.
Jack bolt
Figure 90: Radial sleeve bearing housing assembly
11. Position the dowel pins between the upper and lower halves of the bearing housing. Tighten the
bearing-housing hex screws.
12. Install a new oil filter (550A) and filter plug (113Q).
6.6.9 Assemble the thrust end (sleeve/tilt pumps)
1.
Prior to beginning assembly, push the rotor assembly towards the thrust end until it stops.
2.
Install the cartridge mechanical seal (383) on the shaft (122) and align the mechanical seal pilot
with the seal chamber bore of the casing. Install the mechanical seal studs (353) and hex nuts
(355).
NOTICE:
Do not set the mechanical seal sleeve set screws at this time; endplay must be checked first or
damage to the seal faces could occur.
3.
Install the inboard labyrinth seal (333A).
Figure 91: Thrust inboard labyryth seal installation
NOTICE:
Make sure the expulsion port is at the 6 o’clock position and is properly seated.
4.
Lift the lower half of the bearing housing (134A) into place.
6.6 Reassembly
Model 3600 i-FRAME API610 11th Edition / ISO 13709 2nd Edition to current API BB3 Multi-Stage, Axially Split Installa-
tion, Operation, and Maintenance Manual
117
Summary of Contents for GOULDS PUMPS 3600 i-FRAME
Page 2: ......
