NOTICE:
Make sure that the expulsion port is at the 6 o'clock position and is properly seated.
7.
Hand-tighten the lower housing to the case bearing flange with the case-to-bearing housing studs
(371T) and nuts (427J).
8.
Install the sleeve bearing (117):
a) Apply Lucas Heavy Duty Oil Stabilizer, or equivalent lubricant to the upper half of the sleeve
bearing (117). Place the lower half of the sleeve bearing (117) onto the shaft (122) and slide it
around the shaft into the lower bearing housing, moving the oil rings accordingly. Position the
inboard oil rings in the groove on the sleeve bearings.
b) Install the dowel pins (469J) in the pre-drilled dowel pin holes between the housing flange and
the case bearing flange.
469J
427J
134
Figure 89: Radial bearing housing installation
c)
Tighten the nuts (427J) on the bearing housing to the case studs (371T).
d) Apply Lucas Heavy Duty Oil Stabilizer, or equivalent lubricant to the upper half of the sleeve
bearing (117). Place the upper half of the sleeve bearing (117) on the shaft, moving the oil rings
aside. When the bearing top half is in place, move the oil rings back into the bearing housing
and sleeve groove.
9.
Install the outboard labyrinth seal (332A).
NOTICE:
Make sure that the expulsion port is at the 6 o'clock position and is properly seated.
10. Install the upper half of the bearing housing (134).
Prior to installing the upper half, apply a thin even coat of Permatex
®
Aviation Form-A-Gasket
®
(or
equivalent) to the lower half bearing housing to prevent possible oil seepage.
6.6 Reassembly
116 Model 3600 i-FRAME API610 11th Edition / ISO 13709 2nd Edition to current API BB3 Multi-Stage, Axially Split Installa-
tion, Operation, and Maintenance Manual
Summary of Contents for GOULDS PUMPS 3600 i-FRAME
Page 2: ......
