7.
Install the oil ring (114).
8.
Install the end-cover gasket on the outboard side (360A).
9.
Assemble the outboard labyrinth seal (332A) into the outboard radial-end cover (160):
a) Clean the end cover with a solvent.
b) Fit the labyrinth seal (332A) into the bore of the cover (160).
c)
Tap the seal in with a hammer.
NOTICE:
Make sure that the expulsion port is at the 6 o'clock position and is properly seated.
10. Install the end cover (160). Tighten all end-cover capscrews (371D).
11. Install a new oil filter (550A) and filter plug (113Q).
6.6.7 Assemble the thrust end (sleeve/ball bearing pumps)
1.
Prior to beginning assembly, push the rotor assembly towards the thrust end until it stops.
2.
Install the cartridge mechanical seal (383) on the shaft (122) and align the mechanical seal pilot
with the seal chamber bore of the casing. Install the mechanical seal studs (353) and hex nuts
(355).
NOTICE:
Do not set the mechanical seal sleeve set screws at this time; endplay must be checked first or
damage to the seal faces could occur.
3.
Install the inboard labyrinth seal (333A).
333A
Figure 82: Inboard labyrinth seal installation
NOTICE:
Make sure that the expulsion port is at the 6 o'clock position and is properly seated.
4.
Place the inboard oil ring (114) on the shaft (122).
6.6 Reassembly
Model 3600 i-FRAME API610 11th Edition / ISO 13709 2nd Edition to current API BB3 Multi-Stage, Axially Split Installa-
tion, Operation, and Maintenance Manual
111
Summary of Contents for GOULDS PUMPS 3600 i-FRAME
Page 2: ......
