4 of 36
REGLO ICC - ENGLISH , REV. D, 14-036-E
18.6 System
31
18.6.1 Get pump fi rmware version
31
8.6.2 Set pump’s temporary display name
31
18.6.3 Serial number
31
8.6.4 Language
31
18.6.5 Channel count
32
18.6.6 Roller count
32
18.6.7 Total Revolutions
32
18.6.8 Volume total
32
18.6.9 Time total
32
18.7 Events
33
18.7.1 Channel stop
33
18.7.2 Channel status update
33
19. Regulatory Information
34
19.1 Manufacturing Information
34
19.2 CE Conformity
34
19.3 International Standards
34
19.4 CE Marketing
35
19.5 Connected Equipment
35
17. Event Messages
25
17.1 Channel Stop
26
17.2 Channel Status update
26
18. Examples
27
18.1 Communication Management
27
18.1.1 Get serial protocol version
27
18.1.2 Event message enable
27
18.2 Pump Drive
27
18.2.1 Start pumping
27
18.2.2 Stop pumping
27
18.2.3 Get direction
27
18.2.4 Set direction
28
18.3 Modes and Settings
28
18.3.1 Operational pumping mode
28
18.3.2 Pumping rate (drive speed)
28
18.3.3 Pumping rate (volume/time)
28
18.3.4 Volume
28
18.3.5 Run time
29
18.3.6 Pause time
29
18.3.7 Cycle Count
29
18.4 Confi guration
29
18.4.1 Tubing Inside Diameter
29
18.4.2 Backsteps
29
18.5 Calibration
30
18.5.1 Volume (target)
30
18.5.2 Volume (measured)
30
18.5.3 Time
30
18.5.4 Get time since last calibration
30
18.5.5 Start calibration
30
18.5.6 Cancel calibration in progress
31
We recommend that you read this operating manual
carefully. When operating a pump, certain hazards
cannot be excluded. MASTERFLEX is not liable for any
damage resulting from the use of an ISMATEC
®
pump.
MASTERFLEX is not responsible for the unsafe handling
of chemicals.
