8 of 36
REGLO ICC - ENGLISH , REV. D, 14-036-E
8
6.3 Changing Parameters
Changing parameters is done by moving the cursor around the LCD screen
using the four directional arrows. The arrows are used to navigate the menus
and change numeric values and pumping modes. Using the arrows, the cursor
can be moved to any fi eld to select or edit.
Once the cursor is in the fi eld that you would like to select or edit, press the
OK/Enter button. When highlighting numeric values, the cursor will highlight
the entire value. Pressing OK/Enter will then allow the cursor to highlight only
one digit for editing. Using the directional arrows up or down will increase or
decrease the value and left and right will move the cursor to the next digit to
be edited. Once the value is correct, press OK/Enter and the cursor will then highlight the
entire value exiting the edit mode. When highlighting pumping modes, tubing ID, and
language, the OK/Enter button will allow the parameter to be changed by toggling through a
list using the directional arrows. Once the selection has been made, pressing the OK/Enter
button will save the selection and exit the editing mode.
The Run/Stop button is used to start or stop all the channels. When the pump is
idle, pressing the Run/Stop button will start pumping to the settings for each
channel. When the pump is running, pressing the Run/Stop button will stop all
channels. If a timed or repeating pumping mode is being used, pressing the
Run/Stop button will pause the program. Pressing the Run/Stop button again
will resume the program.
The Reset button is used to cancel editing or reset pumping modes. When a
fi eld has been selected for editing, pressing the Reset button will exit the
editing mode and restore the original value. Also, when the pump is paused,
pressing the Reset button will reset all the pumping modes back to their start
point (number of cycles, time, volumes, etc.).
6.4 Menus
6.4.1 STATUS Menu
The STATUS Menu has three screens. The Status screen (a) displays the current pumping
parameters for each channel. The unit displayed varies depending on the pumping mode
selected. The Total Volume screen (b) displays the total volume that has been pumped since the
last time it was reset. The Total Time screen (c) displays the total hours pumped for each channel
since the last time it was reset. The time and volume can be reset by navigating to the desired
value and pressing OK/Enter button. Highlighting the arrow in the upper right hand corner of the
screen and pressing the OK/Enter button will toggle through the three status screens.
a.
b.
c.
