4-54
Getting Started
Chapter 4
Signal Times
The symbol
is indicated by the column pointer.
External signal devices, e.g. a horn for the organisation of breaks or the plant
illumination can be switched on and off at defined times by the programming of
signal circuit.
Contrary to the check of individuals the signal circuit works person-independent, that
means the release of the signal completely takes place according to defined time
intervals.
The settings for signal time and duration for the signal circuit can be determined
separately for each weekday, same as in the menu "Ribbon colour change".
Up to 16 signal times can be programmed per weekday,
If no times are entered for one weekday, e.g. on Saturday or Sunday there will be no
signal in the corresponding day.
The programming is identical to the proceeding "Column change timing - standard
recorder with one card lift per day".
D1 = signal duration in seconds
- - = the belonging time value will be erased
D2 = Hours
D3 = Minutes
Change or Erase Signal Times
All time values programmed can be changed or erased at any time. Details to the
following proceeding can be find in the previous proceeding.
Proceeding
1.
Call up programming routine (key "
R
").
2.
Select menu "Signal times" (key "
S
").
3.
Select weekday with values to be changed (key "
R
").
4.
Select value to be changed (advance with "
E
").
5.
Change signal duration and/or signal time (key "
R
").
To change further values on the same weekday repeat steps 4 and 5.
6.
Quit entry for this weekday (key "
S
").
To change any values on other weekdays repeat steps 3 to 6.
7.
Quit menu "Signal times" (key "
S
").
8.
Quit programming mode (advance to the end of the menu symbols with "
S
").
→
Current date is displayed.
If you want to erase single values of a weekday, proceed as described above. To
erase the time value displayed, select " "--" with "
R
in the field D1. Confirm with "
E
".
Now the next time value programmed is displayed.