© ioSelect Inc.
CONFIDENTIAL
78
io
Select
EtherWave - WMR
6.0 Configuration
Destination Unit
1-65535
Values
As the name implies, this register specifies the ultimate destination
for an EtherWave-WMR’s data. Different network topologies dictate
the configuration of the Destination Unit (address):
For a Remote in a Point-to-Multipoint network, this menu option will
not appear: by definition, the destination is the Master (UA = 1).
For the Master in PMP, its Destination Unit (Address) is 65535—the
broadcast address as it sends its data to all points.
In a Point-to-Point configuration, the destination is to be specified
(for a Remote: the Master); in the Master’s Radio Configuration,
specify the Unit Address of the Remote Unit to which it is to send its
data.
In Peer-to-Peer, the Remotes are configured with the target peer’s
UA as the Destination Address, the Master with 65535; in
Everyone-to-Everyone, the Destination Address for ALL units is
65535 - the broadcast address - as every unit sends its data to
every other unit (through the Master). E2E is a very bandwidth
intensive network topology.
Tx Control
On
Off
Values
This configuration option does not apply to a Master EtherWave-
WMR.
On (the default) permits the EtherWave-WMR to transmit, i.e. RF
emissions are enabled.
Off configures the EtherWave-WMR for RECEIVE ONLY. If ‘Off’ is
selected, ‘On’ may only be selected LOCALLY or via a special UDP
packet sent from the DiscoverIP Utility.
