Goodrive300-01 inverter for air compressor Function parameters
-72-
Function
code
Name
Detailed instruction of parameters
Default
value
Modif
y
P13.14
Braking retention
time before
starting
circuit braking.
When the running frequency is lower than P01.09
during the stopping of the inverter, set 13.15 to a
non-zero value to enter into stopping short circuited
braking and then carry out the DC braking at the time
set by P01.12 (refer to the instruction of
P01.09~P01.12) .
Setting range of P13.13: 0.0~150.0% (inverter)
Setting range of P13.14: 0.00~50.00s
Setting range of P13.15: 0.00~50.00s
0.00s
○
P13.15
The braking
retention time
when stopping
0.00s
○
P14 Group Serial communication
P14.00
Local
communication
address
The setting range: 1~247
When the master is writing the frame, the
communication address of the slave is set to 0; the
address is the communication address. All slaves on
the MODBUS bus can receive the frame, but the
salve does not respond.
The communication of the drive is unique in the
communication net. This is the fundamental for the
point to point communication between the upper
computer and the inverter.
Note: The address of the slave cannot set to 0.
2
○
P14.01
Communication
baud ratio
Set the digital transmission speed between the
upper computer and the inverter.
0: 1200BPS
1: 2400BPS
2: 4800BPS
3: 9600BPS
4: 19200BPS
5: 38400BPS
6: 57600BPS
7: 115200BPS
Note: The baud rate between the upper computer
and the inverter must be the same. Otherwise,
the communication is not applied. The bigger the
baud rate, the quicker the communication speed.
4
○
P14.02
Digital bit
checkout
The data format between the upper computer and
the inverter must be the same. Otherwise, the
communication is not applied.
1
○
