IntesisBox
®
KNX
– Mitsubishi Electric A.C.
User's manual r2.3 eng
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SLU
URL
Email
tel
http://www.intesisbox.com
[email protected]
+34 938047134
44 / 63
4.9
Binary Input “x” Configuration dialog
Figure 4.41
Binary Input Configuration dialog
All the parameters in this section are related with the binary inputs properties and
communication objects.
4.9.1 Enable use of
Input “x”
This parameter enable
s the use of the Input “x” and
shows/hides the
Status_ Inx
communication object(s)
which will act as configured in the “Function” parameter.
o
If set to
“no”
the objects will not be shown.
o
If set to
“yes”
the
Status_ Inx
object(s) and new parameters will appear.
4.9.2 Contact type
This parameter lets choose the behavior that will have the binary input depending on if the
contact is normally open or normally closed.
o
There are two possible options to configure the contact type:
“NO: Normally Open”
and
“NC: Normally Closed”
.
4.9.3 Debounce time
This parameter lets choose a debounce time (in milliseconds) that will be applied to the
contact.
