IntesisBox
®
KNX
– Mitsubishi Electric A.C.
User's manual r2.3 eng
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SLU
URL
Email
tel
http://www.intesisbox.com
[email protected]
+34 938047134
33 / 63
4.6.2
Transmission of “Status_ AC Return Temp”
This parameter lets to you choose if the AC return temperature will be sent
“only
cyclically
”
,
“only on change”
or
“cyclically and on change”
. The AC return
temperature is sent through the communication object
Status_ AC Return Temp.
Figure 4.27
Parameter detail
➢
“Status_ AC Return Temp” periodic sending time (in sec)
This parameter will only be available for the
“only
cyclically
”
and
“cyclically and
on change”
options, and
let’s
you change the interval of time (in seconds, from 1 to
255) at the end of which the AC return temperature is sent to the KNX bus.
4.6.3 Enable use of +/- object for Setpoint Temp
This parameter shows/hides the
Control_ Setpoint Temp +/-
communication object which
lets change the indoor unit setpoint temperature by using two different datapoint types.
o
If set to
“no”
the object will not be shown.
o
If set to
“yes”
the
Control_ Setpoint Temp +/-
object and a new parameter will appear.
Figure 4.28
Parameter detail
➢
DPT type for +/- Setp Temp object
This parameter lets choose between the datapoints
0-Up / 1-Down [DPT_1.008]
and
0-Decrease / 1-Increase [DPT_1.007]
for the
Control_ Setpoint Temp +/-
object.
▪
Up / Increase
▪
Down / Decrease
…
19ºC
20ºC
28ºC
27ºC
(Upper limit)
(Lower limit)
