IntesisBox
®
KNX
– Mitsubishi Electric A.C.
User's manual r2.3 eng
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SLU
URL
Email
tel
http://www.intesisbox.com
[email protected]
+34 938047134
12 / 63
o
If set to
“yes”
the
Status_ Operation Hour Counter
object will appear.
•
This object can be read and sends its status every time an hour is counted.
The gateway keeps that count in memory and the status is sent also after a
KNX bus reset/failure. Although this object is marked as a
Status_
object it
also can be written to update the counter when needed. To reset the counter
should be written a
“0”
value.
Important:
This object comes by default without the write
(W)
flag
activated. If is necessary to write on it, this flag must be activated.
Important:
This object will also return its status, every time a value is
written,
only if it’s different fr
om the existing one.
Important:
If the stored value is 0 hours, the gateway will not send the
status to KNX.
4.1.6
Enable object “Error Code [2byte]”
This parameter shows/hides the
Status_ Error Code
communication object which shows the
indoor unit errors, if occurred, in numeric format.
o
If set to
“no”
the object will not be shown.
o
If set to
“yes”
the
Status_ Error Code [2byte]
object will appear.
•
This object can be read and also sends the indoor unit error, if occurred, in
numeric format. If a
“0”
value is shown that means no error.
4.1.7
Enable object “Error Text Code [14byte]”
This parameter shows/hides the
Status_ Error Text Code
communication object which
shows the indoor unit errors, if occurred, in text format.
o
If set to
“no”
the object will not be shown.
o
If set to
“yes”
the
Status_ Error Text Code
object will appear.
•
This object can be read and also sends the indoor unit error, if occurred, in
text format. The errors shown have the same format as at the remote
controller and at the error list from the indoor unit manufacturer. If the
object’s value is empty that means no error.
