IntesisBox
®
KNX
– Mitsubishi Electric A.C.
User's manual r2.3 eng
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SLU
URL
Email
tel
http://www.intesisbox.com
[email protected]
+34 938047134
11 / 63
o
If set to
“no”
the remote controller will work as usually. It also appears a new
parameter and the communication object
Control_ Lock Remote Control
.
Figure 4.5
Communication object and parameter detail
➢
Enable comm obj “Ctrl_ Remote Lock”:
If set to
“no”
the object will not be shown.
If set to
“yes”
the
Control_ Lock Remote Control
object will appear.
•
When a
“1”
value is sent to this communication object, the remote controller
is locked. To be unlocked a
“0”
value must be sent. The gateway remembers
the last value received even if a KNX bus reset/failure happens.
Important:
If an initial scene is enabled and it has as Value for Remote Lock
(unchanged) or unlocked, this would unlock the remote controller because the
initial scene has priority over the Control_ Lock Remote Control
communication object.
4.1.4
Enable func “Control_ Lock Control Obj”
This parameter shows/hide the
Control_ Lock Control Obj
communication object which,
depending on the sent value, locks or unlocks ALL the
Control_
communication objects
except itself.
o
If set to
“no”
the object will not be shown.
o
If set to
“yes”
the
Control_ Lock Control Objects
object will appear.
•
When a
“1”
value is sent to this communication object, all the
Control_
objects will be locked. To unlock a
“0”
value must be sent, as the gateway
remembers the last value received even if a KNX bus reset/failure happens.
4.1.5
Enable func “Operating Hours Counter”
This parameter shows/hides the
Status_ Operation Hour Counter
communication object
which counts the number of operating hours for the ME-AC-KNX-1i.
o
If set to
“no”
the object will not be shown.