IntesisBox
®
KNX
– Mitsubishi Electric A.C.
User's manual r2.3 eng
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SLU
URL
Email
tel
http://www.intesisbox.com
[email protected]
+34 938047134
29 / 63
Figure 4.23
Parameter detail
➢
DPT type for +/- Vane Up-Down obj
This parameter lets choose between the datapoints
0-Up / 1-Down [DPT_1.008]
and
0-Decrease / 1-Increase [DPT_1.007]
for the
Control_ Vanes U-D +/-
object.
➢
Does +/- sequence include AUTO vanes Up-Down?
This parameter lets choose if AUTO function is included (
“yes”
) or not (
“no”
) in the
sequence when using
Control_ Vanes U-D +/-
object as shown in the discontinuous
segment at the picture below.
➢
Does +/- sequence include SWING vanes Up-Down?
This parameter lets choose if SWING function is included (
“yes”
) or not (
“no”
) in
the sequence when using
Control_ Vanes U-D +/-
object as shown in the
discontinuous segment at the picture below.
➢
Roll over Vanes at upper/lower limit
This parameter lets choose if roll-over will be enabled (
“yes”
) or disabled (
“no”
) for
the
Control_ Vanes U-D +/-
object.
4.5.6 Enable use of bit-type Vane U-D objects (for Control)
This parameter shows/hides the bit-type
Control_ Vanes U-D
objects.
▪
Up / Increase
▪
Down / Decrease
*
If Available
AUTO*
P. 3
P. 1
P. 2
Only if Roll-over is enabled
Only if Roll-over is enabled
P. 5*
P. 4
SW*