IntesisBox
®
KNX
– Mitsubishi Electric A.C.
User's manual r2.3 eng
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SLU
URL
Email
tel
http://www.intesisbox.com
[email protected]
+34 938047134
32 / 63
4.5.11 Enable use of Legacy_ object for Vanes
This parameter shows/hides the
Legacy_ Vanes
communication object
o
If set to
“no”
the communication object will not be shown.
o
If set to
“yes”
the communication object will appear. This object lets change the indoor
unit vanes behavior but it uses a different data type. It is used to maintain compatibility
with old gateway models.
4.6 Temperature Configuration dialog
Figure 4.25
Default Temperature Configuration dialog
All the parameters in this section are related with the Temperature properties and
communication objects.
4.6.1 Periodic sending
of “Status_ AC Setp”
This parameter lets change the interval of time (in seconds, from 0 to 255) at the end of
which the AC setpoint temperature is sent to the KNX bus. For a
“0”
value, the AC setpoint
temperature will ONLY be sent on change. The AC setpoint temperature is sent through the
communication object
Status_ AC Setpoint Temp.
Figure 4.26
Parameter detail
Important:
In case the ambient temperature is provided from KNX, the setpoint
temperature returned from this object, will be the one resulting from the formula shown
in the section
“
2.6.5
Ambient temp. ref. is provided from KNX”.