IntesisBox
®
KNX
– Mitsubishi Electric A.C.
User's manual r2.3 eng
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SLU
URL
Email
tel
http://www.intesisbox.com
[email protected]
+34 938047134
36 / 63
Figure 4.29
Parameter detail
o
If set to
“no”
the scene parameters and communication objects will not be shown.
o
If set to
“yes”
the scene parameters and communication objects will be shown. To
execute a scene through the byte-type object, a value from
“
0
”
to
“
4
”
has to be sent,
correponding each one to a different scene (i.e.
“
0
”
= Scene 1;
…
“
4
”
= Scene 5).
4.7.2 Scenes can be stored from KNX bus
This parameter shows/hides the
Control_ Save/Exec Scene
and all the
Control_ Store Scene
(if enabled)
communication objects.
o
If set to
“no”
the communication objects will not be shown.
o
If set to
“yes”
the communication objects and a new parameter will appear. To store a
scene through the byte-type object, a value from
“128”
to
“132”
has to be sent to the
object, correponding each one to a different scene (i.e.
“
128
”
= Scene 1;
…
“
132
”
=
Scene 5).
Figure 4.30
Parameter detail
➢
Enable use of bit objects for storing scenes (from bus)
If set to
“no”
the objects will not be shown.
If set to
“yes”
the
Control_ Store Scene
objects for storing scenes will appear. To
store a scene by using these objects, a
“1”
value has to be sent to the scene’s
object we want to store (i.e. to store scene 4, a
“1”
has to be sent to the
Control_
Store Scene 4
object).
4.7.3 Enable use of bit objects for scene execution
This parameter shows/hides the
Control_ Execute Scene
bit-type communication objects.