Intergraph TD-20 Setup, Setup Manual

Page: 43 / 66

31
NOTE TD-20 and TD-200 systems have different sound processors and require different sound
processor drivers. TD-20 systems use the Sound Blaster driver; TD-200 systems use the
Crystal Audio driver.
To install Windows 95:
1. Insert the Windows 95 boot diskette in the floppy disk drive.
2. Insert the Windows 95 CD-ROM in the CD-ROM drive.
3. Start or restart the system.
4. At the Windows 95 Startup Menu, select the option to install Windows 95.
If you are installing Windows 95 on a system on which another operating system or a previous
version of Windows 95 exists, you may have to partition and format the system’s hard disk
before installing Windows 95. An option on the Startup Menu allows you to exit to MS-DOS
and use the fdisk and format commands.
CAUTION Make a backup copy of your data and/or programs before partitioning and formatting the
system’s hard disk. All data on the hard disk is destroyed by fdisk and format. Once you
have completed these tasks and re-installed Windows 95, you must re-install any application
software and data that you want to use.
CAUTION Make sure that all disk drives attached to the system are partitioned, and formatted with the
File Allocation Table (FAT) file system, before attempting to install Windows 95, or the
installation will fail.
Follow the instructions in Introducing Windows 95 to install Windows 95. As you install the
operating system:
u
You can safely select the default responses during the Setup process.
u
Allow Setup to configure the network only if you have an installed network adapter, and
then only if the system is connected to the network.
u
When prompted to create a Startup Diskette, do so.
u
While Windows 95 files are being copied to the system, you are prompted for the
Windows 95 Setup Boot Diskette. This occurs even if the Windows 95 boot diskette is
already inserted in the floppy disk drive. Select OK to continue.
Next, you are notified that the
MTMCDAI
.
SYS
file could not be found on the Windows 95
Setup Boot Diskette. In the dialog that displays, specify that the file should be copied
from a:\, and then select OK.
After installing the operating system:
u
Install drivers or other system software from any backup diskettes. System software
delivered on backup diskette is usually more current than system software on the
operating system CD-ROM.