Intergraph TD-20 Setup, Setup Manual

Page: 41 / 66

29
u
Perform any operational changes required for your system as described in Chapter 4,
“Operating Notes.”
u
You can install additional accessories for the sound processor, available from the
Intergraph Bulletin Board Service (IBBS) or from vendor bulletin boards pointed to by
the IBBS.
As shipped from the factory, the system’s hard disk drive contains Windows NT Workstation
Setup files in the
C
:\
I
386 directory. When installing network or video display adapter drivers,
you can refer to the
I
386 directory when prompted for the location of Windows NT
Workstation Setup files. If you delete the
I
386 directory from the system’s hard disk, you
must have access to a Windows NT Workstation CD-ROM to use Windows NT Workstation
Setup files.
Windows NT Workstation 3.51
Depending on your system’s configuration, you will need some or all of the following system
software (on backup diskette or on the operating system CD-ROM) during installation:
u
SCSI adapter driver
u
G76, G95, or Intense 3D Pro video display driver
u
Network adapter driver
u
Sound processor driver
u
Mouse driver
u
Windows NT 3.51 Service Pack 4 software
u
QFE update software
NOTE TD-20 and TD-200 systems have different sound processors and require different sound
processor drivers. TD-20 systems use the Sound Blaster driver; TD-200 systems use the
Crystal Audio driver.
Follow the instructions in the Installation Guide to install Windows NT Workstation 3.51. As
you install the operating system:
u
When prompted to select a Setup type, select Express Setup.
u
When Setup lists the components of the system and asks you to make changes if needed,
select the No Changes option.
u
When prompted to let Setup detect the network adapter, let it do so only if one is installed
in the system, and then only if the system is connected to the network.