Intel SRCU31, User Manual

Page: 24 / 182

24 Intel RAID SRCU31 Users Guide
RAID Hardware Installation and Setup
Minimum Hardware Requirements
•
Computer with CD-ROM drive (not attached to the Intel RAID Controller SRCU31).
Computer must be on the supported hardware list (for example, Intel
®
server board STL2). For
a supported list refer to:
http://support.intel.com/support/motherboards/server/
•
One 32-bit, 33 MHz PCI compatible slot
•
PCI 2.2 compliant System BIOS
•
SCSI hard disk drive(s) (the minimum required to meet the desired RAID level)
Install a High Profile Backplate to the Intel RAID Controller
SRCU31
1. Remove both backplate screws on the backplate edge of the controller.
2. Remove the attached backplate.
3. Position the backplate and attach with two screws.
Installing and Removing the SDRAM
Installing the SDRAM
1. With clips A1 and A2 in the open position (position 2), insert the DIMM into the DIMM
connector (the DIMM and connector are keyed to ensure proper insertion).
CAUTION
Align the DIMM carefully so as not to damage the conductor pads on the DIMM and in the
connector. Apply firm pressure but do not force.
2. With the thumbs positioned on each end of the DIMM and two fingers on the DIMM
connector, press the thumb and fingers firmly together until the DIMM clips snap into the close
position (position 1).
Removing the SDRAM
1. With the thumbs on the DIMM clips, swing the clips from the close position to the open
position.
2. Grasp the corners of the DIMM with both hands and firmly pull from the DIMM connector.
Install the Intel RAID Controller SRCU31 in the Intel
®
Server
Board
The RAID firmware has already been programmed into the memory. Prior to installing the Intel
RAID Controller SRCU31 into the computer, an approved memory module must be installed in the
controller. For a list of approved memory modules refer to: