Intel SR2600UR - Server System - 0 MB RAM, Service Manual

Page: 139 / 234

Intel
®
Server System SR2600UR/SR2625UR Service Guide 119
10. If necessary, install the I/O expansion module. For instructions, see “Installing the
I/O Expansion Module” on page 96 .
11. If necessary, install the Intel
®
RMM3. For instructions, see “Installing the Intel
®
RMM3” on page 98 .
12. Connect all additional cables to the server board as necessary.
13. Install the processor air duct. For instructions, see
“Installing the Processor Air
Duct” on page 57 .
14. Install the PCI riser assembly. For instructions, see “Installing the PCI Riser
Assembly” on page 51 .
Replacing the Backup Battery
The lithium battery on the server board powers the RTC for up to 10 years in the absence
of power. When the battery starts to weaken, it loses voltage, and the server settings stored
in CMOS RAM in the RTC (for example, the date and time) may be wrong. Contact your
customer service representative or dealer for a list of approved devices.
Warning: Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type recommended by the equipment manufacturer. Discard used batteries
according to manufacturer's instructions.
Advarsel: Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering. Udskiftning må kun ske med
batteri af samme fabrikat og type. Levér det brugte batteri tilbage til leverandøren.
Advarsel: Lithiumbatteri - Eksplosjonsfare. Ved utskifting benyttes kun batteri som anbefalt av
apparatfabrikanten. Brukt batteri returneres apparatleverandøren.
Varning: Explosionsfara vid felaktigt batteribyte. Använd samma batterityp eller en ekvivalent typ
som rekommenderas av apparattillverkaren. Kassera använt batteri enligt fabrikantens
instruktion.
Varoitus: Paristo voi räjähtää, jos se on virheellisesti asennettu. Vaihda paristo ainoastaan
laitevalmistajan suosittelemaan tyyppiin. Hävitä käytetty paristo valmistajan ohjeiden
mukaisesti.
To replace the backup battery, follow these steps:
1. If installed, remove the PCI riser assembly. For instructions, see “Removing the
PCI Riser Assembly” on page 50 .
2. If installed, remove the processor air duct. For instructions, see “Removing the
Processor Air Duct” on page 56 .
3. Locate the battery on the server board (see Figure 111 ).
4. Insert the tip of a small flat bladed screwdriver, or an equivalent, under the tab in
the plastic retainer. Gently push down on the screwdriver to lift the battery.