Intel SR1600UR - Server System - 0 MB RAM, Service Manual

Page: 81 / 190

Intel
®
Server System SR1600UR Service Guide 63
Figure 51. Removing Retention Device from Drive Carrier
4. Remove the hard drive from its wrapper and place it on an antistatic surface.
5. Set any jumpers and/or switches on the drive according to the drive manufacturer's
instructions.
6. With the drive circuit-side down, position the connector end of the drive so that it is
facing the rear of the drive carrier.
7. Align the holes in the drive to the holes in the drive carrier and attach it to the
carrier with the screws that were attached to the plastic retention device.
Figure 52. Installing Hard Drive into Carrier
8. With the carrier lever in the open position, slide the drive assembly into the server
system and push all the way until it stops (see letter “A” in Figure 53 ).
9. Close the lever to lock the drive assembly into place (see letter “B” in Figure 53 ).
Figure 53. Installing Drive Assemby into the Server System
B
A
AF002944
AF002945
AF002946
A
B