Intel SR1600UR - Server System - 0 MB RAM, Service Manual, Page: 102 / 190

84 Intel
®
Server System SR1600UR Service Guide
Removing and Installing the Server Board
Removing the Server Board
To remove the server board, follow these steps:
1. If installed, remove the PCI riser assembly. For instructions, see “Removing the
PCI Riser Assembly” on page 41 .
2. If installed, remove the processor air duct. For instructions, see “Removing the
Processor Air Duct” on page 46 .
3. If installed, remove the blue air baffle. For instructions, see “Removing the Small
Air Baffle” on page 57 .
4. Hot-swap hard drive systems with passive backplane only: Disconnect the hard
drive SATA cables from the server board.
5. Hot-swap hard drive systems only: If installed, remove the bridge board. For
instructions, see step 4 in “Removing the Backplane Board” on page 82 .
6. Remove the system fan assembly. For instructions, see “Removing the System Fan
Assembly” on page 91 .
7. Disconnect all power cables coming from the power supply to the server board.
8. Remove the I/O expansion module, if installed. For instructions, see
“Removing
the I/O Expansion Module” on page 70 .
9. Remove the Intel
®
RMM3, if installed. For instructions, see “Removing the Intel
®
RMM3” on page 74 .
10. If installed, remove memory, processor heatsink(s), and processor(s) from the
server board. For instructions, see “Removing DIMMs” on page 50 and “Removing
the Heatsink” on page 55 .
11. Remove the nine screws from the server board (see letter “A” in Figure 74 ) and lift
the server board from the server system (see letter “B” in Figure 74 ).