Intel SR1600UR - Server System - 0 MB RAM, Service Manual

Page: 56 / 190

38 Intel
®
Server System SR1600UR Service Guide
Removing the Front Bezel
To remove the front bezel, follow these steps:
1. Unlock the bezel.
2. Pull the bezel from the server system.
Figure 23. Removing the Front Bezel
Removing and Installing the System Cover
Removing the System Cover
The server system must be operated with the system cover in place to ensure proper
cooling. You will need to remove the top cover to add or replace components inside of the
server. Before removing the system cover, power down the server and unplug all
peripheral devices and the AC power cable(s).
Note: A nonskid surface or a stop behind the server system may be needed to prevent the server
system from sliding on your work surface.
To remove the server system cover, follow these steps:
1. Remove the safety screw if it is installed (see letter "A" in Figure 24 ).
2. While holding in the blue button at the top of the server system in (see letter "B" in
Figure 24 ), slide the top cover back until it stops (see letter "C" in Figure 24 ).
3. Insert your finger in the notch (see letter “D” in Figure 24 ) and lift the cover
upward to remove it.
AF002880