8
INSTALLING DVXi TS9 D and DVXi TBC9 D
Use Figure 2 to complete the following installation instructions.
1.
Plug the power cord into the power connector (A).
2.
Plug the mouse into the mouse connector (B).
3.
Plug the keyboard into the keyboard connector (C).
4.
To provide a network or dial-up connection, connect a network cable to
the network connector (D) or a phone line to the optional modem (J).
5.
Plug the monitor into the monitor connector (E) and electrical outlet.
6.
(Optional) Wire the alarms to the green trigger block (F). From top to
bottom are board inputs 1–16, an output, and a ground. On the
MasterControl Alarms tab, the inputs are named Board Alarm 1, Board
Alarm 2, and so on. Connect only to voltages below 42V DC; external
devices connected to the DVXi system should be in a SELV, non-energy
hazardous circuit.
7.
Connect up to five cameras to the first (left) row of BNC connectors (G).
These inputs are labeled 1 through 5 from bottom to top.
8.
Connect up to four cameras to the second (right) row of BNC connectors
(H). These inputs are labeled 6 through 9 from bottom to top. For video
output, connect a VCR or external TV/monitor to the connector labeled
OUTPUT (top).
9.
(Optional) Connect your PTZ cameras to the RS-422 port (K) as described
in the PTZ installation manual.
10. Plug the power cord into an electrical outlet.
11. To provide power to the DVXi box, use the power switch on the rear
panel (L).
12. To turn on the DVXi system, use the power switches on the front panel of
the box and on the monitor.
