Integra DTR-70.2, Instruction Manual

Page: 99 / 124

99
En
You can reset a Remote Mode to its default remote con-
trol code.
You can reset the remote controller to its default settings.
By pressing
Remote Mode
that’s been programmed with
the remote control code for your component, you can con-
trol your component as below.
For details on entering a remote control code for other
components, see “Entering Remote Control Codes”
(
➔
98 ).
Controlling a TV
TV is preprogrammed with the remote control code for
controlling a TV that supports the
p *1
(limited to
some models). The TV must be able to receive remote
control commands via
p
and be connected to the
AV receiver via HDMI. If controlling your TV via
p
doesn’t work very well, program your TV’s
remote control code into
TV
and use the TV remote mode
to control your TV.
Controlling a Blu-ray Disc/DVD Player, HD
DVD Player or DVD Recorder
BD/DVD is preprogrammed with the remote control code
for controlling a component that supports the
p
*1
(limited to some models). The component must be able to
receive remote control commands via
p
and be
connected to the AV receiver via HDMI.
*1 The p supported by the
AV receiver
is the CEC
system control function of the HDMI standard.
Resetting Remote Mode Buttons
1
While holding down Remote Mode that you want
to reset, press and hold down Home until Remote
Mode button lights (about 3 seconds).
2
Within 30 seconds, press
Remote Mode
again.
Remote Mode button flashes twice, indicating that
the button has been reset.
Each of
Remote Mode is preprogrammed with a
remote control code. When a button is reset, its pre-
programmed code is restored.
Note
•
The learning command is also reset.
Resetting the Remote Controller
1
While holding down Receiver , press and hold
down Home until Receiver lights (about 3 sec-
onds).
2
Within 30 seconds, press
Receiver
again.
Receiver flashes twice, indicating that the remote
controller has been reset.
Controlling Other Components