Integra DTR-70.2, Instruction Manual

Page: 103 / 124

103
En
Note
• The remote controller can learn approximately 70 to 90 com-
mands, although this will be less if commands that use a lot of
memory are learned.
• Remote controller buttons such as Play, Stop, Pause, and so on
are preprogrammed with commands for controlling
Integra/Onkyo CD players, cassette decks, and DVD players.
However, they can learn new commands, and you can restore the
preprogrammed commands at any time by resetting the remote
controller (
➔
99
).
• To overwrite a previously learned command, repeat this proce-
dure.
• Depending on the remote controller that you are using, there may
be some buttons that won’t work as expected, or even some
remotes that cannot be learned at all.
• Only commands from infrared remote controllers can be learned.
• When the remote controller’s batteries expire, all learned com-
mands will be lost and will have to be learned all over again, so
don’t discard your other remote controllers.
■
Deleting Learning Commands
1. While holding down
Remote Mode
for the mode in
which you want to delete the command, press and hold
down
TV
9
until Remote Mode button lights
(about 3 seconds).
2. Press
Remote Mode
or the button from which you
want to delete the commands.
Remote Mode button flashes twice.
When you press Remote Mode , all commands
learned in that remote mode will be deleted.
You can program the remote controller’s Activities to
perform a sequence of remote control actions.
Example:
To play a CD you typically need to perform the following
actions:
1. Press
Receiver to select the Receiver remote control-
ler mode.
2. Press On to turn on the AV receiver.
3. Press
TV/CD
to select the TV/CD input source.
4. Press 1 to start playback on the CD player.
You can program Activities so that all four actions are
performed with just one button press.
Making Macros
Each
Activities
can store one macro, and each macro can
contain up to 32 commands.
Running Macros
Deleting Macros
Using Normal Macros
Receiver
My Movie,
My TV,
My Music
All Off
1
While holding down
Receiver
, press and hold
down
My Movie
,
My TV
, or
My Music
until
My Movie
,
My TV
, or
My Music
lights (about 3
seconds).
2
Press the buttons whose actions you want to pro-
gram into the macro in the order you want them
performed.
For the CD example above, you’d press the following
buttons:
On
,
TV/CD
,
1
.
Note
•
Mode
is invalid at macro making operation.
3
When you’ve finished, press Activities again.
Activities button flashes twice.
If you enter 32 commands, the process will finish
automatically.
Note
• Once you have taught new macro commands, the original
macro will no longer work. If you retrieve it, you will have
to taught again.
Press
My Movie
,
My TV
, or
My Music
.
The commands in the macro are transmitted in the
order in which they were programmed. Keep the
remote controller pointed at the AV receiver until all
of the commands have been transmitted.
Macros can be run at any time, regardless of the cur-
rent remote controller mode.
1
While holding down Home , press and hold down
All Off until All Off lights (about 3 seconds).
2
Press All Off again.
All Off flashes twice.
Note
• You can use Easy macro when the macro is deleted
(
➔
28 ).
• When you use Normal macro, you cannot use the easy
macro command including the change of the source com-
ponent.