Integra DTR-70.2, Instruction Manual

Page: 72 / 124

72
En
Setting the Incoming Digital Signal (Fixed
Mode)
By pressing Enter while selecting “ HDMI ”, “ COAX ”,
“ OPT ” in the “ Audio Selector ”, you can specify the input
signal in the Fixed Mode. Pressing Enter again allows
you to return to the “ Audio Selector ” setting.
Normally, the AV receiver detects the signal format auto-
matically. However, if you experience either of the follow-
ing issues when playing PCM or DTS material, you can
manually set the signal format to PCM or DTS.
• If the beginnings of tracks from a PCM source are cut
off, try setting the format to PCM.
• If noise is produced when fast forwarding or reversing a
DTS CD, try setting the format to DTS.
■
Fixed Mode
`
Auto :
The format is detected automatically. If no digital
input signal is present, the corresponding analog
input is used instead.
`
PCM :
Only 2-channel PCM format input signals will be
heard. If the input signal is not PCM, the
PCM indi-
cator will flash and noise may also be produced.
`
DTS :
Only DTS (but not DTS-HD) format input signals
will be heard. If the input signal is not DTS, the
DTS
indicator will flash and there will be no sound.
Note
• The setting is stored individually for each input selector.
• The setting will be reset to “
Auto ” when you change the setting
in the “ Audio Selector ” (
➔
71 ).