Integra DTR-70.2, Instruction Manual

Page: 98 / 124

98
En
You’ll need to enter a code for each component that you
want to control.
Note
• The remote control codes provided are correct at the time of
printing, but are subject to change.
Integra/Onkyo components that are connected via u are
controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, or you want to
control an Integra/Onkyo component that’s not connected
via
u
, use the following remote control codes:
• BD/DVD
`
30627 :
Integra/Onkyo DVD player without u
• TV/CD
`
71817 :
Integra/Onkyo CD player without
u
`
11807 :
TV with
p
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, use the follow-
ing remote control codes:
`
32900 :
Integra/Onkyo Blu-ray Disc player
`
32901 :
Integra/Onkyo HD DVD player
`
70868 :
Onkyo MD recorder without u
`
71323 :
Onkyo CD recorder without
u
`
82990 :
Onkyo Dock without
u
Entering Remote Control Codes
1
Look up the appropriate remote control code in
the separate Remote Control Codes list.
The codes are organized by category (e.g., DVD
player, TV, etc.).
2
While holding down Remote Mode to which you
want to enter a code, press and hold down Dis-
play (about 3 seconds).
The Remote Mode button lights.
Note
• Remote control codes cannot be entered for
Receiver
and Zone .
• Only TV remote control codes can be entered for TV .
• Except for Receiver , TV and Zone , remote control
codes from any category can be entered as Remote
Mode
. However, these buttons also work as input selector
buttons (
➔
25 ), so choose a Remote Mode that corre-
sponds with the input to which you connect your compo-
nent. For example, if you connect your CD player to the
CD input, choose
TV/CD when entering its remote control
code.
3
Within 30 seconds, use the number buttons to
enter the 5-digit remote control code.
Remote Mode
button flashes twice.
If the remote control code is not entered success-
fully,
Remote Mode button will flash once slowly.
Remote Control Codes for Integra/
Onkyo Components Connected via
u
1
Make sure the Integra/Onkyo component is con-
nected with an
u cable and an analog audio
cable (RCA).
See “Connecting Integra/Onkyo
u
Components”
for details (
➔
20 ).
2
Enter the appropriate remote control code for
Remote Mode .
• BD/DVD
`
31612 :
Integra/Onkyo DVD player with
u
• Tape
`
42157 :
Onkyo cassette tape deck with
u
• TV/CD
`
71327 :
Integra/Onkyo CD player with
u
•
Port
`
81993 :
Onkyo Dock with
u
See the previous section for how to enter remote
control codes.
3
Press Remote Mode , point the remote controller
at the AV receiver, and operate the component.