INSYS Modem 56k small EU 2.1
S Registry
67
S8*
Dial tone delay
Dial pause time, if a comma is included in the dialling string. If there is a comma in
the dialling string, the modem will wait during the dialling procedure, until the
time specified in S8 (in seconds) has expired. The value of S8 can be between 1
and 7 seconds.
S9*
Reaction time for carrier signal
DCD response time for the carrier frequency from the other modem. The DCD
output of the RS232 interface (CT109) of the modem switches to ON, when the
carrier frequency from the other modem is detected before the time defined in S9
(in tenth of seconds) expires. S9 must be smaller than S10.
S10*
Time period between lost carrier signal and hang up
The time which leads to termination after carrier frequency loss. In S10, the time
period for which the modem waits for the disconnection if it can no longer detect
the carrier frequency from the other modem, is specified in tenth of seconds.
S12*
Transmission clock of the ESC characters
Minimum pre and post run time and maximum interim time in 1/50 of seconds
between two characters. This must be observed, if the modem is supposed to de-
tect an abort sequence (u++).
S14*
General
settings
Bit
Meaning
Bit 0
Reserved
Bit 1
Echo on inputs
Command echo
0: Echo off
1:
Echo
on
Bit 2
Reserved
Bit 3
Result format
Result codes:
0: Message numbers (
ATV0
)
1: Message texts (
ATV1
)
Bit 4
Reserved
Bit 5
Tone/pulse dialling
Tone/pulse
0: Tone dialling (
ATT
)
1: Pulse dialling (
ATP
)
Bit 6
Reserved
Bit 7
Originate/answer
Originate/answer 0:
Answer
mode
1: Originate mode
