Initial Operation
INSYS Modem 56k small EU 2.1
22
10
Initial Operation
This chapter describes how to activate the INSYS Modem 56k small EU 2.1, i.e. how
to connect the INSYS Modem 56k small EU 2.1 to a PC, to a telephone network and
how to test it.
Connect the INSYS Modem 56k small EU 2.1to a PC
How to connect the INSYS Modem 56k small EU 2.1 to a PC via a serial in-
terface.
You will need the 9-pin serial cable.
You will need a free serial interface at the PC.
Use preferably serial interfaces which are actually at the PC as "real" hard-
ware. Virtual serial interfaces or USB-to-Serial solutions often cause prob-
lems.
1.
Connect the 9-pin serial cable with the INSYS Modem 56k small EU 2.1 and
fasten the connection screws.
2.
Connect the 9-pin serial cable to a free serial interface of your PC.
Note or remember to which interface (COM1 or COM2) you connected the
INSYS Modem 56k small EU 2.1 at the PC.
Connect the INSYS Modem 56k small EU 2.1 to the telephone network
You will need the supplied phone cord
1.
Plug the RJ12 jack of the cable into the RJ45 phone connection at the INSYS
Modem 56k small EU 2.1.
2.
Plug the TAE or RJ12 jack of the cable into the phone socket of your phone
connection.
Test the INSYS Modem 56k small EU 2.1
The INSYS Modem 56k small EU 2.1 is connected to the PC.
The power supply of the INSYS Modem 56k small EU 2.1 is switched on.
A terminal program such as TeraTerm is installed at the PC.
1.
Open your terminal program.
2.
Open the serial interface, to which the INSYS Modem 56k small EU 2.1 is con-
nected.
3.
Enter
AT
into your terminal program.
The response will be
OK
.
